6.Probe

Built-in probe model

The system has built-in NOKOV Probe Template (9.6.1),Model: LY-0020;

6.1

1. Take the NOKOV probe-LY-0020 in the middle of the field, click Freeze, select the probe Markers, right-click the mouse and select "Create Probe", select "Built-in", select "LY-0020" as the template, and click 'Create' (9.6.2) ;

9.6.2

1. After successfully creating the probe, the asset Interface will display the information of the created probe, and the 3D view will show the rigid body of the created probe;

Note: Other probes cannot be successfully created using the built-in probe template;

Custom probe model

1. Stand the custom probe upright in the middle of the field, click Freeze, select the probe points by dragging a box around them, right-click the mouse and choose "Create Probe," then select the 'Custom' from the displayed window;

2. Enter the probe name and calibration frames, then click Create. (In custom mode, clicking Create will automatically unfreeze the state);

3. At this point, rotate the probe around a fixed point to form a cone shape and capture the specified number of frames. After collecting the required frames, the 3D view will display the created probe rigid body;

Note: While rotating the probe, ensure that the tip of the probe remains fixed at a point and does not move.

Note: Clicking Cancel during the collection process will stop data collection and calibration.

Probe Properties

1. After selecting the probe asset, click on the probe properties icon (9.6.3) to display the properties window (9.6.4) ;

9.6.3

9.6.4

1. On this page, clicking on "Calibrate" allows for recalibration of the selected and created probe. In real-time probe measurements, the real-time probe tip data is displayed;

2. After clicking on "Calibrate," the interface will show the probe data collection status. At this point, rotate the probe around a fixed point to form a cone shape and start collecting data for calibration. Clicking Cancel will stop the calibration process. Upon completing the calibration, the updated rigid body will be displayed in the view;